Super Systems PC Configurator 2 - Manual (Page 161)

Super Systems Inc. Page 161 of 201 Configurator Manual #4562 Rev D
drop-down list from which the user can select a new PVT Type. The values for the PVT type
are: % Carbon, Dew Point, % O2, Millivolts, Multi-loop, Vacuum, IR + Probe,
Nitrider, % Carbon + Dual Temp, or Cascade.
Temperature Mode:
This value determines the specific temperature scale to be used. It can be either Degrees
°F or
degrees °C.
Atmosphere Instrument:
The option will allow the user to select the instrument that will serve as the atmosphere
instrument. The options are: Internal Loop 1 – Internal Loop 3, Instrument 1 –
Instrument 25.
Temperature Instrument:
Allows for a slave instrument (or internal) to be the defined temperature control device. The
types of instruments are: Internal Loop 1 – Internal Loop 3, Instrument 1 –
Instrument 25.
Event Instrument:
Allows for a slave instrument (or internal) to be the defined event control device. The types of
instruments are: Internal, Instrument 1 – Instrument 25.
Quench Instrument:
Allows for slave instrument (or internal) to be the defined quench control device. The types of
instruments are: Internal Loop 1 – Internal Loop 3, Instrument 1 – Instrument 25.
End of Quench Event:
Tells the programmer which event to signal end of quench (related to which relay it is
assigned). The list of possible values is: 0 – 14.
Quench Speed Event:
Tells the programmer which event will signal the quench speed. The list of possible values is: 0
– 14.
Quench Run Event:
Tells the programmer which event will signal quench run. The list of possible values is: 0 – 14.
Televac on RS-232:
This value determines if there is a televac on the RS-232 port. The list of options are either No
or Yes.
Date and Time:
Displays the current date and time.
PLC Type:
This value defines the type of PLC being used. The options are: Micrologix Modbus,
MCMmodule Modbus, DF1 PLC5, or DF1 Slik.