19 spanning-tree portfast, 20 spanning-tree digest-snooping – Accton Technology ES4626 User Manual

Page 234

Advertising
background image

234

Switch(Config)#spanning-tree mst 2 priority 4096

7.3.19 spanning-tree portfast

Command: spanning-tree portfast

no spanning-tree portfast

Function:

Set the current port as boundary port; The command “no spanning-tree

portfast

” sets the current port as non-boundary port.

Command mode:

Interface Mode

Default:

All the ports are non-boundary ports by default when enabling MSTP.

Usage Guide:

When a port is set to be a boundary port, the port converts its status from

discarding to forwarding without bearing forward delay. Once the boundary port receives

the BPDU, the port becomes a non-boundary port.

Example:

Set port 1/5-6 as boundary ports.

Switch(Config)#interface ethernet 1/5-6

Switch(Config-Port-Range)#spanning-tree portfast

7.3.20 spanning-tree digest-snooping

Command:spanning-tree digest-snooping

no spanning-tree digest-snooping

Function:

Configure the port to use the authentication string of partner port .the

command “no spanning-tree digest-snooping“ restores to use the port generated

authentication string.

Default:

Don’t use the authentication string of partner port .

Command mode:

Interface mode

Usage Guide:

According to MSTP protocol, the region authentication string is generated

by MD5 algorithm with public authentication key,intstance ID, VLAN ID. Some

manufactory don’t user the public authentication key, this cause the incompatibility . After

the command is executed the port can use the authentication string of partner port ,

realize compatibility with these manufactories equipment .

Note:Because the authentication string is related to instance ID and VLAN ID, the

command may cuase recognizing the equipment that with different instance and VLAN

relation as in the same region. Before the command is executed, make sure that instance

and VLAN relation is accord for all the equipment. If there are more than one equipment

connected , all the connected ports should executed this command.

Example:

Switch(Config)#interface ethernet 1/2

Switch(Config-Ethernet-1/2)#spanning-tree digest-snooping

Advertising
This manual is related to the following products: