Accton Technology ES4626 - Manual (Page 468)

468
SwitchE#config
SwitchE(config)# interface vlan 2
SwitchE(config-if-vlan2)# ip address 100.1.1.2 255.255.255.0
SwitchE(config-if-vlan2)#no shut-down
SwitchE(config-if-vlan2)#exit
Configuration of the IP address for interface vlan3
SwitchE(config)# interface vlan 3
SwitchE(config-if-vlan3)# ip address 30.1.1.1 255.255.255.0
SwitchE(config-if-vlan3)#no shut-down
SwitchE(config-if-vlan3)#exit
Enable OSPF protocol, configure the number of the area in which interface vlan2
and vlan3 reside in.
SwitchE(config)#router ospf
SwitchE(config-router)# network 30.1.1.0/24 area 0
SwitchE(config-router)# network 100.1.1.0/24 area 0
SwitchE(config-router)#exit
SwitchE(config)#exit
Scenario 2： Typical OSPF protocol complex topology.
Fig 13-7Typical complex OSPF autonomous system.
This scenario is a typical complex OSPF autonomous system network topology.
Area1 include network N1-N4 and layer3 SwitchA-SwitchD, area2 include network
N8-N10, host H1 and layer3 SwitchH, area3 include N5-N7 and layer3 SwitchF, SwitchG
Area3 Area2
Area1
N3
N1
N8
N5
N6
N9
N10
N4
N2
N15 N14
N7
N11
Area0
SwitchA
SwitchB
SwitchC
SwitchD
SwitchE
SwitchF
SwitchI
SwitchL
SwitchK
SwitchJ
SwitchG
SwitchH
N12
N13