Accton Technology ES4626 - Manual (Page 696)

696
Ipv6 pim hello-holdtime <value>
no ipv6 pim hello-holdtime
Configure the value of holdtime domain in
interface PIM-SM hello message; the NO
operation of this command restores the
default value.
3） Configure PIM-SM Neighbor Access-list
Command Explanation
Port Configuration Mode
(no)ipv6 pim neighbor-filter
<access-list-name>
Configure Neighbor Access-list. If a neighbor
is filtered by the list and a connection has
been set up with this neighbor, then this
connection will be cut off immediately; and if
no connection is set up yet, then this
connection can’t be created.
（2）Configure PIM-SM Global Parameters
1） Configure switch to be candidate BSR
Command Explanation
Global Mode
Ipv6 pim bsr-candidate <ifname>
[hash-mask-length] [priority]
no ipv6 pim bsr-candidate
This command is the global candidate BSR
configuration command, which is used to
configure the information of PIM-SM
candidate BSR so that it can compete for
BSR router with other candidate BSRs. The
NO operation is to cancel the configuration of
BSR.
2） Configure switch to be candidate RP
Command Explanation
Global Mode
Ipv6 pim rp-candidate <ifname>
[<group range>] [<priority>]
(no) ipv6 pim rp-candidate
<ifname>
This command is the global candidate RP
configuration command, which is used to
configure the information of PIM-SM
candidate RP so that it can compete for RP
router with other candidate RPs. The NO
operation is to cancel the configuration of RP.
3） Configure Static RP
Command Explanation
Global Mode