3 telnet, 1 introduction to telnet, 2 telnet configuration task list – Accton Technology ES4626 User Manual
Page 49
49
Ping6 command is mainly used by the switch to send ICMPv6 query packet to the
remote equipment, verifying the accessibility between the switch and the remote
equipment. Options and explanations of the parameters of the Ping6 command please
refer to Ping6 command chapter in the command manual.
2.2.3 Telnet
2.2.3.1 Introduction To Telnet
Telnet is a simple remote terminal protocol for remote login. Using Telnet, the user
can login to a remote host with its IP address of hostname from his own workstation.
Telnet can send the user’s keystrokes to the remote host and send the remote host
output to the user’s screen through TCP connection. This is a transparent service, as to
the user, the keyboard and monitor seems to be connected to the remote host directly.
Telnet employs the Client-Server mode, the local system is the Telnet client and the
remote host is the Telnet server. ES4624-SFP/ES4626-SFP switch can be either the
Telnet Server or the Telnet client.
When ES4624-SFP/ES4626-SFP switch is used as the Telnet server, the user can
use the Telnet client program included in Windows or the other operation systems to login
to ES4624-SFP/ES4626-SFP switch, as described earlier in the In-band management
section. As a Telnet server, ES4624-SFP/ES4626-SFP switch allows up to 5 telnet client
TCP connections.
And as Telnet client, using telnet command under Admin Mode allows the user to
login to the other remote hosts. ES4624-SFP/ES4626-SFP switch can only establish TCP
connection to one remote host. If a connection to another remote host is desired, the
current TCP connection must be dropped.
2.2.3.2 Telnet Configuration Task List
1. Configuring
Telnet
Server
2. Telnet to a remote host from the switch.
1. Configuration of Telnet Server
Command Explanation
Global Mode
ip telnet server
no ip telnet server
Enable the Telnet server function in the
switch: the “no ip telnet server”
command disables the Telnet function.
telnet-server securityip <ip-addr>
Configure the secure IP address to