Accton Technology ES4626 - Manual (Page 430)

430
Function: Set the RIP layer 3 switches to block RIP broadcast on the specified interfaces,
and only send the RIP data packet to the layer 3 switch which is configured with
neighbor.
Parameter: <ifname> is the specific interface name
Default: Not configured
Command Mode: Router mode
Example: Switch# config terminal
Switch(config)# router ipv6 rip
Switch(config-router)# passive-interface Vlan1
13.5.3.11 redistribute
Command:[no]redistribute {kernel |connected| static| ospf| isis| bgp}
[metric<value>] [route-map<word>]
Function: Introduce the routes learnt from other routing protocols into RIP
Parameter: kernel introduce from kernel routes
connected introduce from direct routes
static introduce from static routes
ospf introduce from IPv6 OSPF routes
isis introduce from IPv6 ISIS routes
bgp introduce from IPv6 BGP routes
<value> is the metric value assigned to the introduced route, ranging between
0-16
<word>
is the probe poining to the route map for introducing routes
Command Mode: Router mode
Example: Switch# config terminal
Switch(config)# router ipv6 rip
Switch(config-router)# redistribute kernel route-map ip
13.5.3.12 route
Command: route <ipv6-address>
no route <ipv6-address>
Function: This command configures a static RIP route. The “no route
<ipv6-address> “ command deletes this route.
Parameter: Specifies this destination IPv6 address prefix and its length show in
colon hex notation.
Usage Guide: The command add a static RIPng route, and is mainly used for
debugging. Routes configured by this command will not appear in kernel route
table but in the RIP route database, however it could be located by using the show