Accton Technology ES4626 - Manual (Page 454)

454
Switch#config terminal
Switch(config)#interface vlan 1
Switch(Config-if-Vlan1)#ip ospf cost 3
13.6.3.19 ip ospf database-filter
Command: ip ospf [<ip-address>] database-filter all out
no ip ospf [<ip-address>] database-filter
Function: The command opens LSA database filter switch on specific interface; the “no
ip ospf [<ip-address>] database-filter
” command closes the filter switch.
Parameter: <ip-address> is the interface IP address shown in dotted decimal notation;
all: All LSAs
out: Sent LSAs
Default: Filter switch Closed
Command Mode: Interface Mode
Example:
Switch#config terminal
Switch(config)#interface vlan 1
Switch(Config-if-Vlan1)#ip ospf database-filter all out
13.6.3.20 ip ospf dead-interval
Command: ip ospf [<ip-address>] dead-interval <time >
no ip ospf [<ip-address>] dead-interval
Function:
Specify the dead interval for neighboring layer 3 switch; the “no ip ospf
[<ip-address>] dead-interval ” command restores the default value.
Parameter: <ip-address> is the interface IP address shown in dotted decimal notation;
<time > is the dead interval length of the neighboring layer 3 switches, shown in seconds
and ranging between 1~65535
Default: The default dead interval is 40 seconds (normally 4 times of the hellow-interval).
Command Mode: Interface Mode
Usage Guide:
If no HELLO data packet received after the dead-interval period then this
layer 3 switch is considered inaccessible and invalid. This command modifies the dead
interval value of neighboring layer 3 switch according to the actual link state. The set
dead-interval value is written into the Hello packet and transmitted. To ensure the normal
operation of the OSPF protocol, the dead-interval between adjacent layer 3 switches
should be in accordance or at least 4 times of the hello-interval value
Example: Switch#config terminal
Switch(config)#interface vlan 1
Switch(Config-if-Vlan1)#ip ospf dead-interval 80