Accton Technology ES4626 - Manual (Page 370)

370
Switch(config)#route-map r1 permit 5
Switch(config-route-map)#match community 100 exact-match
13.2.3.5 match interface
Command: match interface <interface-name >
no match interface [<interface-name >
Function: Configure to match the interfaces. The “no match interface
[<interface-name > “ deletes this configuration.
Parameter:
“ <interface-name >“ is the name of the interface.
Command Mode: route-map mode
Usage Guide: This command matches according to the next-hop messages in the route.
If the matching succeeded, then the “permit” or “deny” action in the route-map is
performed. This command is only used in RIP and OSPF protocols.
Example: Switch#config terminal
Switch(config)#route-map r1 permit 5
Switch(config-route-map)#match interface vlan1
13.2.3.6 match ip
Command: match ip <address | next-hop> <ip-ACL-name | ip-ACL-num |
prefix-list list-name>
no match ip <address | next-hop> [<ip-ACL-name | ip-ACL-num |
prefix-list list-name>]
Function:
Configure the routing prefix or next-hop. The “no match ip <address |
next-hop> [<ip-ACL-name | ip-ACL-num | prefix-list list-name>] ” deletes this
configuration.
Parameter: <address > means matching the routing prefix, <next-hop>means matching
the routing next-hop, <ip-ACL-name > is the name of ip access-list, <ip-ACL-num > is
the ip access-list sequence number, ranging between 1～199 or 1300～2699（extension
scope）, prefix-list means the matching should follow the prefix-list rules, list-name is
the name of prefix-list.
Command Mode: route-map mode
Usage Guide: This command matches according to the next-hop messages or routing
prefix in the route. If the matching succeeded, then the “permit” or “deny” action in the
route-map is performed.
Example:
Switch#config terminal
Switch(config)#route-map r1 permit 5
Switch(config-route-map)#match ip address prefix-list mylist