43 neighbor allowas-in, 44 neighbor attribute-unchanged – Accton Technology ES4626 User Manual

Page 544

Advertising
background image

544

Switch(config-router)#neighbor 10.1.1.64 advertisement-interval 20

Switch(config-router)#no neighbor 10.1.1.64 advertisement-interval

Switch(config-router)#

13.8.3.43 neighbor allowas-in

Command:neighbor {<ip-address>|<TAG>} allowas-in [<1-10>]

no neighbor {<ip-address>|<TAG>} allowas-in

Function:

Configure the counts same AS is allowed to appear in the neighbor route AS

table. The “no neighbor {<ip-address>|<TAG>} allowas-in” restores to not allow any

repeat

Parameter: <ip-address>

: IP address of the neighbor

<TAG>

: Name of the peer group

<1-10>: Allowed count of same AS number

Default:

In default conditions AS is not allowed repeating in the same route, and when

set the repeat count it is defaulted at 3 when <1-10> parameters not set.

Command Mode:

BGP route mode and address family mode

Usage Guide:

Normally BGP will not allow same AS number appears in the route more

than one time. The system will deny a route when its AS number appears in the AS-PATH.

However to support some special needs, especially the VPN support, the extended BGP

allows the AS re-appear counts by configuration. This command is for configure the

re-appear counts

Example:

Switch(config-router)#neighbor 10.1.1.66 allowas-in

13.8.3.44 neighbor attribute-unchanged

Command:

neighbor {<ip-address>|<TAG>} attribute-unchanged

[as-path][med][next-hop]

no neighbor {<ip-address>|<TAG>} attribute-unchanged [as-path] [med]

[next-hop]

Function:

Configure certain attributes which is kept unchanged for transmitting, namely

the attribute transparent transmission. The “no neighbor {<ip-address>|<TAG>}

attribute-unchanged [as-path] [med] [next-hop]

” command means the attribute

transparent transmission is not performed.

Parameter: <ip-address>

: IP address of the neighbor

<TAG>

: Name of the peer group

Default:

No attribute transparent defined

Command Mode:

BGP route mode and address-family mode

Usage Guide:

With this configuration specified route attributes will not change when

transmitted to the specified neighbor. The BGP route mode is the IPv4 unicast

Advertising
This manual is related to the following products: