Accton Technology ES4626 - Manual (Page 699)

699
Parameter: <priority> priority, it ranges from 0 to 4294967294
Default:
1
Command Mode: Interface Configuration Mode
Usage Guide: Range from 0 to 4294967294, the higher value has more priority. The
command can configure on IPv6 tunnel interface, but it is successful configuration to only
configure tunnel carefully.
Example: Switch (Config)# interface vlan 1
Switch(Config-if-Vlan1)ipv6 pim dr-priority 100
17.2.3.5 ipv6 pim exclude-genid
Command : ipv6 pim exclude-genid
no ipv6 pim exclude-genid
Function: This command makes the Hello packets sent by PIM SM do not include GenId
option, the “no ipv6 pim exclude-genid” command restores the default value
Parameter: None
Default:
The Hello packets include GenId option.
Command Mode: Interface Configuration Mode
Usage Guide : This command is used to interact with older Cisco IOS version. The
command can configure on IPv6 tunnel interface, but it is successful configuration to only
configure tunnel carefully.
Example: Configure the Hello packets sent by the switch do not include GenId option
Switch(Config-if-Vlan1)#ipv6 pim exclude-genid
17.2.3.6 ipv6 pim hello-holdtime
Command: ipv6 pim hello-holdtime <value>
no ipv6 pim hello-holdtime
Function: Configure or disable the Holdtime option in the Hello packets, this value is to
describe neighbor holdtime,if the switch hasn’t received the neighbor hello packets when
the holdtime is over, this neighbor is deleted.
Parameter: <value>
is the value of holdtime.
Default: The default value of Holdtime is 3.5*Hello_interval, Hello_interval’s default value
is 30s,so Holdtime’s default value is 105s.
Command Mode: Interface Configuration Mode
Usage Guide: If this value is not configured, hellotime’s default value is
3.5*Hello_interval. If the configured holdtime is less than the current hello_interval , this
configuration is denied. Every time hello_interval is updated, the Hello_holdtime will
update according to the following rules: If hello_holdtime is not configured or
hello_holdtime is configured but less than current hello_interval,hello_holdtime is