Accton Technology ES4626 - Manual (Page 628)

628
no ip pim exclude-genid
Function:
This command makes the Hello packets sent by PIM SM do not include GenId
option. The “no ipv6 pim exclude-genid” command restores the default value
Parameter: None
Default: The Hello packets include GenId option.
Command Mode: Interface Configuration Mode
Usage Guide: This command is used to interact with older Cisco IOS version.
Example: Configure the Hello packets sent by the switch do not include GenId option.
Switch (Config-if-Vlan1)#ip pim exclude-genid
Switch (Config-if-Vlan1)#
16.3.3.6 ip pim hello-holdtime
Command: ip pim hello-holdtime <value>
no ip pim hello-holdtime
Function: Configure or disable the Holdtime option in the Hello packets, this value is to
describe neighbor holdtime,if the switch hasn’t received the neighbor hello packets when
the holdtime is over, this neighbor is deleted. The “no ip pim hello-holdtime” command
cancels configured holdtime value and restores default value.
Parameter: <value> is the value of holdtime.
Default: The default value of Holdtime is 3.5*Hello_interval, Hello_interval’s default value
is 30s,so Hold time’s default value is 105s.
Command Mode: Interface Configuration Mode
Usage Guide:
If this value is not configured, hellotime’s default value is
3.5*Hello_interval. If the configured holdtime is less than the current hello_interval , this
configuration is denied. Every time hello_interval is updated, the Hello_holdtime will
update according to the following rules: If hello_holdtime is not configured or
hello_holdtime is configured but less than current hello_interval,hello_holdtime is
modified to 3.5*hello_interval, otherwise the configured value is maintained.
Example: Configure vlan1’s Hello Holdtime
Switch (Config)# interface vlan1
Switch (Config -if-Vlan1)#ip pim hello-holdtime 10
Switch (Config -if-Vlan1)#
16.3.3.7 ip pim hello-interval
Command: ip pim hello-interval <interval>
no ip pim hello-interval
Function: Configure the interface’s hello_interval of pim hello packets. The “no ip pim
hello-interval
” command restores the default value.