Accton Technology ES4626 - Manual (Page 300)

300
and vlan3 connects to IPv4 domain.
4、 Configure IPv6 address 2002:cbcb:cb01:2::1/64 in vlan4 of SwitchB and turn on
RA function, configure IPv4 address 203.203.203.1 on vlan3.
5、 Configure tunnel on SwitchA, the source IPv4 address of the tunnel is
202.202.202.1, the tunnel routing is ::/0
6、 Configure tunnel on SwitchB, the source IPv4 address of the tunnel is
202.202.202.2, and the tunnel routing is ::/0
7、 Configure two vlans on SwitchC, namely, vlan2 and vlan3. Configure IPv4
address 202.202.202.202 on vlan2 and configure IPv4 address 203.203.203.203
on vlan3.
8、 PC-A and PC-B get the prefix of 2002 via SwitchA and SwitchB to configure IPv6
address automatically.
9、 On PC-A, ping IPv6 address of PC-B
SwitchA(config)#ipv6 enable
SwitchA(Config-if-Vlan1)#ipv6 address 2002:caca:ca01:2::1/64
SwitchA(Config-if-Vlan1)#no ipv6 nd suppress-ra
SwitchA(Config-if-Vlan1)#interface vlan 2
SwitchA(Config-if-Vlan2)#ipv4 address 202.202.202.1 255.255.255.0
SwitchA(Config-if-Vlan1)#exit
SwitchA(config)# interface tunnel 1
SwitchA(Config-if-Tunnel1)#tunnel source 202.202.202.1
SwitchA(Config-if-Tunnel1)#tunnel destination 203.203.203.1
SwitchA(Config-if-Tunnel1)#tunnel mode ipv6ip
SwitchA(config)#ipv6 route ::/0 tunnel1
SwitchB(config)#ipv6 enable
SwitchB(Config-if-Vlan4)#ipv6 address 2002:cbcb:cb01::2/64
SwitchB(Config-if-Vlan4)#no ipv6 nd suppress-ra
SwitchB (Config-if-Vlan3)#interface vlan 3
SwitchB (Config-if-Vlan2)#ipv4 address 203.203.203.1 255.255.255.0
SwitchB (Config-if-Vlan1)#exit
SwitchB(Config)#interface tunnel 1
SwitchB(Config-if-Tunnel1)#tunnel source 203.203.203.1
SwitchB(Config-if-Tunnel1)#tunnel destination 202.202.202.1
SwitchB(Config-if-Tunnel1)#tunnel mode ipv6ip
SwitchB(config)#ipv6 route ::/0 tunnel1
9.2.4 IP Troubleshooting