Accton Technology ES4626 - Manual (Page 547)

547
{<both>|<send>|<receive>} ” command set to not perform the negotiation
Parameter: <ip-address>
: Neighbor IP address
<TAG> : Name of peer group
Default: ORF capability not configured
Command Mode: BGP route mode and address-family mode
Usage Guide: This is an extended BGP capability. With this configuration supported
capabilities by both side will be negotiated in the OPEN messages, and the partner will
respond if this capability is supported by the partner and send NOTIFICATION if not. The
originating side will then send an OPEN excluded the capability to reestablish the
connection. With this capability, the side configured with in prefix-list filter rules will
transmit its own filter rules to the peer, the peer group will apply this rule as its own out
rules, so to avoid sending route which will be denied by the partner.
Example:
Switch(config-router)#neighbor 10.1.1.66 capability orf prefix-list both
Relevant Commands: neighbor capability, no neighbor capability
13.8.3.48 neighbor collide-established
Command: neighbor {<ip-address>|<TAG>} collide-established
no neighbor {<ip-address>|<TAG>} collide-established
Function: Enable the collision check and settlement in the TCP connection collision.
The “no neighbor {<ip-address>|<TAG>} collide-established” command disables the
TCP connection collision settlement
Parameter: <ip-address>
: Neighbor IP address
<TAG> : Name of the peer
Usage Guide: This command is for settling the problem that multi-connection among
peers due to TCP connection collision. Connections created with this option on will
always be check even at established state. And it will be checked if local side IP is larger
than partner IP when collides. If yes, the original connection will be deleted, and if not the
option will be configured to only checks when the connection originated from local side at
open sent and open confirm state.
Command Mode: route mode and address family mode
Default: Disabled and Unavailable
Example: Switch(config-router)#neighbor 10.1.1.64 collide-established
13.8.3.49 neighbor default-originate
Command: neighbor {<ip-address>|<TAG>} default-originate [route-map <WORD>]
no neighbor {<ip-address>|<TAG>} default-originate [route-map <WORD>]
Function:
Configures whether enables transmitting default route to the specific