Accton Technology ES4626 - Manual (Page 549)

549
Function: Configure the policy applied in partner route update transmission. The “no
neighbor {<ip-address>|<TAG>} distribute-list {<1-199>|<1300-2699>|<WORD>}
{in|out} ” command cancels the policy configuration
Parameter: <ip-address> : Neighbor IP address
<TAG> : Name of peer group
<1-199>|<1300-2699>|<WORD> : Number or name of the access-list
Default: Policy not applied
Command Mode: BGP route mode and address-family mode
Usage Guide:
Configure the policies with access-list command and apply this
command on route sending and receiving. It will filter the update route from partner when
use in mode, and will filter the route from local side to partner with out mode.
Example:
Configure the access-list
Switch(config)#access-list 101 deny ip 100.1.0.0 0.0.1.255 any
Switch(config)#access-list 101 permit ip any any
Switch(config)#router bgp 100
Switch(config-router)# neighbor 10.1.1.66 distribute-list 101 out
13.8.3.52 neighbor dont-capability-negotiate
Command: neighbor {<ip-address>|<TAG>} dont-capability-negotiate
no neighbor {<ip-address>|<TAG>} dont-capability-negotiate
Function: Set to not perform capability negotiate in creating connections. The “no
neighbor {<ip-address>|<TAG>} dont-capability-negotiate
” command cancels this
configuration.
Parameter: <ip-address> : Neighbor IP address
<TAG> : Name of the peer group
Default: Capability negotiation performed
Command Mode: BGP route mode and address-family mode
Usage Guide: As the negotiation is the default, it can be disabled with this configuration
when it is known that the partner BGP version is old which don’t support capability
negotiation.
Example : Last addition capability negotiation will not be realized in the connection by
configuring as follows.
Switch(config-router)#neighbor 10.1.1.64 dont-capability-negotiate
13.8.3.53 neighbor ebgp-multihop
Command: neighbor {<ip-address>|<TAG>} ebgp-multihop [<1-255>]
no neighbor {<ip-address>|<TAG>} ebgp-multihop [<1-255>]