Accton Technology ES4626 - Manual (Page 537)

537
Default: Automatically acquire router ID
Command Mode: BGP route mode
.
Usage Guide: Manually set the router ID with this command
Example: Switch(config-router)# bgp router-id 1.1.1.1
13.8.3.27 bgp scan-time
Command: bgp scan-time <0-60>
no bgp scan-time [<0-60>]
Function:
Set the time interval of the periodical next-hop validation; the “no bgp
scan-time [<0-60>] ” command restores to the default value
Parameter: <0-60> : Validation time interval
Default: Default interval is 60s
Command Mode: BGP route mode .
Usage Guide: Validate the next-hop of BGP route, this command is for configuring the
interval of this check. Set the parameter to 0 if you don’t want to check
Example:
Switch(config-router)# bgp scan-time 30
13.8.3.28 clear ip bgp
Command: clear ip bgp [view <NAME>] {<*>|<as-id>| external|peer-group
<NAME>|<ip-address>} [<ADDRESS-FAMILY>] [in [prefix-filter] |out|soft [in|out]]
Function: Clear up BGP links or states
Parameter:
all
<as-id> : AS number;
<NAME> : Respectively BGP instance name and peer group name.
<ip-address> : IP address
<ADDRESS-FAMILY> : “ipv4 unicast”.” Address family
Default: None
Command Mode: Admin mode
Usage Guide:
Clearing up BGP state in different parameters (such as AS number, peer
group name, IPv4 address, address-family, external neighbor), or the inbound or
outbound messages. Also it is optional to use the saved ORF as soft reconfiguration, or
use the soft in|out commands for in or out soft reconfiguration if it is already set.
Example:
Switch# clear ip bgp * soft in
When soft reconfiguration is set, use this commands for soft reconfiguration
Switch# clear ip bgp *
Will clear up all established connections