Accton Technology ES4626 - Manual (Page 846)

846
default setting to be restored.
Example:
Set the private IP address pool for the member switches to 192.168.1.64
Switch(config)#cluster ip-pool 192.168.1.64
22.1.3.4 cluster commander
Command:cluster commander <cluster-name> [vlan <vlan-id>]
no cluster commander
Function: Enables a commander switch, create a cluster, or modify a cluster’s name; the
“no cluster commander” command deletes the cluster.
Parameter: <cluster-name> is the cluster’s name; <vlan-id> is the VLAN of the Layer 3
device which the cluster belongs to. If it is omitted, the cluster belongs to VLAN1.
Command mode: Global Mode
Default: There is no cluster by default.
Instructions: This command sets the switch as a commander switch and creates a
cluster. Before executing this command, users must configure a private IP address pool.
If users executes this command again, the cluster’s name will be changed and this
information is distributed to the member switches. If users execute this command in a
member switch, an error will be displayed. If users execute this command again with a
new vlan id, the new vlan id is invalid.
Notice: On layer3 interface configured as cluster commander , avoid configuring
RIP,OSPF routing protocol, otherwise, those routing protocols will not work.
Example: Set the switch as a commander switch. The cluster’s name is admin and the
vlan-id is vlan
Switch(config)#cluster commander admin vlan 2
22.1.3.5 cluster member
Command: cluster member {candidate-sn <cand-sn> | mac-address <mac-add>
[<mem-id>]} [password <pass>]
no cluster member <mem-id >
Function:
Add a candidate switch to the cluster in the commander switch; the “no
cluster member <mem-id > ” command deletes a member switch from the cluster.
Parameter: <mem-id> is the member ID, valid range is 1 to 23; <cand-sn> is the
sequence number of the switch in the candidate switch list, valid range is 0 to 127. Users
can use “;” or “-” to specify multiple numbers or successive numbers; <mac-add> is the
MAC address of the member switch in the format of XX-XX-XX-XX-XX-XX; <pass> is the
privileged password of the member switch.
Command mode:
Global Mode
Instructions: When this command is executed in the commander switch, the switch with