Accton Technology ES4626 - Manual (Page 416)

416
After that, one feature of RIP protocol should be noticed ---the Layer 3 switch
running RIP protocol sending route updating messages to all neighboring Layer 3
switches every 30 seconds. A Layer 3 switch is considered inaccessible if no route
updating messages from the switch is received within 180 seconds, then the route to
the switch will remains in the route table for 120 seconds before it is deleted. Therefore, if
to delete a RIP route, this route item is assured to be deleted from route table after 300
seconds.
When exchanging routing messages with CE using RIP protocol on the PE router,
we should first create corresponding VPN routing/transmitting examples to associate with
corresponding interfaces. Then enter the RIP address family mode configuring
corresponding parameters.
If the RIP routing problem remains unresolved, please use debug rip command to
record the debug message in three minutes, and send them to our technical service
center.
13.4.5.1 Commands for Monitor And Debug
13.4.5.1.1 show debugging rip
Command: show debugging rip
Function: Show RIP event debugging, RIP packet debugging and RIP nsm debugging
status
Command Mode: Any mode
Example: Switch# show debugging rip
RIP debugging status:
RIP event debugging is on
RIP packet detail debugging is on
RIP NSM debugging is on
13.4.5.1.2 show ip protocols rip
Command: show ip protocols rip
Function: Show the RIP process parameter and statistics information
Command Mode: Any mode
Example:
show ip protocols rip
Routing Protocol is "rip"
Sending updates every 30 seconds with +/-50%, next due in 8 seconds
Timeout after 180 seconds, garbage collect after 120 seconds
Outgoing update filter list for all interface is not set
Incoming update filter list for all interface is not set