Accton Technology ES4626 User Manual
Page 73
73
community string.
3.
Configure IP address of SNMP management base
Command
Explanation
snmp-server securityip {<ipv4-address>|
<ipv6-address>}
no snmp-server securityip
{<ipv4-address>| <ipv6-address>}
Configure the secure IPv4/IPv6 address
which is allowed to access the switch on
the NMS; the “no snmp-server securityip
{<ipv4-address>| <ipv6-address>}
“ command deletes configured secure
address.
snmp-server SecurityIP enable
snmp-server SecurityIP disable
Enable or disable secure IP address check
function on the NMS.
4. Configure engine ID
Command
Explanation
snmp-server engineid < engine-string >
no snmp-server engineid <
engine-string >
Configure the local engine ID on the
switch. This command is used for SNMP
v3.
5.
Configure user
Command
Explanation
snmp-server user <user-string>
<group-string> [[encrypted] {auth
{md5|sha} <password-string>}]
no snmp-server user <user-string>
<group-string>
Add a user to a SNMP group. This
command is used to configure USM for
SNMP v3.
6.
Configure group
Command
Explanation
snmp-server group <group-string>
{NoauthNopriv|AuthNopriv|AuthPriv}
[[read <read-string>] [write
<write-string>] [notify <notify-string>]]
no snmp-server group <group-string>
{NoauthNopriv|AuthNopriv|AuthPriv}
Set the group information on the switch.
This command is used to configure VACM
for SNMP v3.
7. Configure view
Command
Explanation
snmp-server view <view-string>
<oid-string> {include|exclude}
no snmp-server view <view-string>
Configure view on the switch. This
command is used for SNMP v3.
8.
Configuring TRAP
Command
Explanation