Accton Technology ES4626 User Manual
Page 517
517
(
6)Configure Next-Hop
1) Set Next-Hop as the switch’s address
Command Explanation
BGP configuration mode
neighbor { <ip-address> | <TAG> }
next-hop-self
no neighbor { <ip-address> | <TAG> }
next-hop-self
While sending route Next-Hop set
Next-Hop as the switch’s address; the no
neighbor { <ip-address> | <TAG> }
next-hop-self
command cancels the
setting.
2)Cancel default Next-Hop through route map
Command Explanation
Route mapped configuration command
set ip next-hop <ip-address>
no set ip next-hop
Set the Next-Hop attribute of outbound
route. The no set ip next-hop command
cancels this setting.
(
7)Configure EGBP Multi-Hop
If the connections with outer neighbors are not direct, the following command can
configure neighbor Multi-Hop.
Command Explanation
BGP configuration mode
neighbor {<ip-address>|<TAG>}
ebgp-multihop [<1-255>]
no neighbor {<ip-address>|<TAG>}
ebgp-multihop [<1-255>]
Configure the allowance of
EBGP connection with other
networks that are not connected
directly; the no neighbor
{<ip-address>|<TAG>}
ebgp-multihop [<1-255>]
command cancels the setting.
(
8)Configure BGP session identifier
Command Explanation
BGP configuration mode
bgp router-id <ip-address>
no bgp router-id
Configure the router-id value; the no bgp
router-id
command recovers the default
value.