Accton Technology ES4626 - Manual (Page 685)

685
PIM-DM switch on relevant interface.
Command Explanation
Global Mode
ipv6 pim multicast-routing
Enable PIM-DM Protocol (but below
commands are required to really function
PIM-DM protocol )
And then turn on PIM-DM switch on the interface
Command Explanation
Port Configuration Mode
ipv6 pim dense-mode
Start PIM-DM Protocol of the interface
(Required)
2. Configure PIM-DM Auxiliary Parameters
（1）Configure PIM-DM Interface Parameters
Configure PIM-DM hello message interval time
Command Explanation
Port Configuration Mode
ipv6 pim hello-interval < interval>
no ipv6 pim hello-interval
Configure PIM-DM hello message interval
time; the NO operation of this command
restores the default value.
Command Explanation
Port Configuration Mode
ipv6 pim state-refresh
origination-interval
no ipv6 pim state-refresh
origination-interval
Configure PIM-DM state-refresh message
interval time; the NO operation of this
command restores the default value.
3. Shut down PIM-DM Protocol
Command Explanation
Port Configuration Mode
no ipv6 pim dense-mode Turn off PIM-DM protocol of the interface
Global Mode
no ipv6 pim multicast-routing Shut down PIM-DM Protocol in global mode.
17.1.3 Commands for PIM-DM6