Accton Technology ES4626 - Manual (Page 559)

559
Example:
Switch(config-router)#no neighbor 10.1.1.66 send-community
Switch(config-router)#neighbor 10.1.1.66 send-community
13.8.3.71 neighbor shutdown
Command: neighbor {<ip-address>|<TAG>} shutdown
no neighbor {<ip-address>|<TAG>} shutdown
Function: Disconnect the neighbor connection. The “no neighbor
{<ip-address>|<TAG>} shutdown
” cancels this configuration
Parameter: <ip-address> : Neighbor IP address
<TAG> : Name of peer group
Default: Not disconnecting
Command Mode: BGP mode and address-family mode
Usage Guide: Directly disconnect/connect to a peer (group) without canceling the
neighbor configuration
Example:
Switch(config-router)#neighbor 10.1.1.64 shutdown
13.8.3.72 neighbor soft-reconfiguration inbound
Command:neighbor {<ip-address>|<TAG>} soft-reconfiguration inbound
no neighbor {<ip-address>|<TAG>} soft-reconfiguration inbound
Function: Configures whether perform inbound soft reconfiguration; the “no neighbor
{<ip-address>|<TAG>} soft-reconfiguration inbound
” command set to not perform the
inbound soft reconfiguration
Parameter: <ip-address> : Neighbor IP address
<TAG> : Name of peer group
Default: Not perform inbound soft reconfiguration
Command Mode: The system saves the inbound messages in the buffer after the soft
reconfiguration is set, will applies as soon as it restarts so to reduce consumptions of
switching with other routers. The command is only available when the route refresh
capability is not enabled
Example:
Switch(config-router)#neighbor 11.1.1.120 soft-reconfiguration inbound
13.8.3.73 neighbor soo
Command: [no] neighbor <ip-addr> soo <soo-val>
Function: Configure the origin source from the neighbor route
Parameter:
The neighbor IP address show in dotted decimal notation