Accton Technology ES4626 - Manual (Page 296)

296
Default： None
Usage Guide： This command can not clear static neighbor.
Example： Clear neighbor list.
Switch #clear ipv6 neighbors
9.2.3 IP Configuration Examples
9.2.3.1 Configuration Examples of IPv4
Fig 9-1 IPv4 configuration example
The user’s configuration requirements are: Configure IPv4 address of different
network segments on SwitchA and SwitchB, configure static routing and validate
accessibility using ping function.
Configuration Description:
1、 Configure two vlans on SwitchA, namely, vlan1 and vlan2.
2、 Configure IPv6 address 192.168.1.1 255.255.255.0 in vlan1 of SwitchA, and
configure IPv4 address 192.168.2.1 255.255.255.0 in vlan2.
3、 Configure two vlans on SwitchB, respectively vlan2 and vlan3
4、 Configure IPv4 address 192.168.2.2 255.255.255.0 in vlan2 of SwitchB, and
configure IPv4 address 192.168.3.1 255.255.255.0 in vlan2.
5、 The IPv4 address of PC-A is 192.168.1.100, and the IPv4 address of PC-B is
192.168.3.100
6、 Configure static routing 192.168.3.0/24 on SwitchA, and configure static routing
192.168.1.0/24 on SwitchB.
7、 Ping each other among PCs.
Note: First make sure PC-A and Switch can access each other by ping, and PC-B
and SwitchB can access each other by ping.
The configuration procedure is as follows:
SwitchA(Config)#interface vlan 1
SwitchA(Config-if-Vlan1)#IP address 192.168.1.1 255.255.255.0
SwitchA
PC-A
PC-B
SwitchB