Accton Technology ES4626 - Manual (Page 630)

630
Example: Configure the interval of timer
Switch (config)#ip pim jp-timer 59
16.3.3.10 ip pim multicast-routing
Command: ip pim multicast-routing
no ip pim multicast-routing
Function: Enable PIM-SM globally. The “no ip pim multicast-routing » command
disables PIM-SM globally.
Parameter:
None
Default: Disabled PIM-SM
Command Mode: Global Mode
Usage Guide: Enable PIM-SM globally. The interface must enable PIM-SM to have
PIM-SM work
Example: Enable PIM-SM globally.
Switch (Config)#ip pim multicast-routing
Switch (Config)#
16.3.3.11 ip pim neighbor-filter
Command: ip pim neighbor-filter{<list-number>}
no ip pim neighbor-filter{<list-number>}
Function: Configure the neighbor access-list. If filtered by the lists and connections with
neighbors are created, this connections are cut off immediately. If no connection is
created, this connection can’t be created.
Parameter: <list-number>: <list-number> i s the simple access-list number, it ranges
from 1 to 99
Default: No neighbor filter configuration.
Command Mode: Interface Configuration Mode
Usage Guide: ACL’s default is DENY. If configuring access-list 1,access-list 1’s default is
deny. In the following example, if “permit any” is not configured, deny 10.1.4.10 0.0.0.255
is the same as deny any.
Example: Configure vlan’s filtering rules of pim neighbors.
Switch #show ip pim neighbor
Neighbor Interface Uptime/Expires Ver DR
Address Priority/Mode
10.1.4.10 Vlan1 02:30:30/00:01:41 v2 4294967294 / DR
Switch (Config-if-Vlan1)#ip pim neighbor-filter 2
Switch (config)#access-list 2 deny 10.1.4.10 0.0.0.255
Switch (config)#access-list 2 permit any