7 ipv6 mld snooping vlan mrouter-port interface, 8 ipv6 mld snooping vlan mrpt – Accton Technology ES4626 User Manual
Page 732
732
Command Mode:
Global Mode
Default:
Maximum 50 groups by default, with each group capable with 40 source entries.
Usage Guide:
When number of joined group reaches the limit, new group requesting for
joining in will be rejected for preventing hostile attacks. To use this command, MLD
snooping must be enabled on vlan. The “no” form of this command restores the default
other than set to “no limit”. For the safety considerations, this command will not be
configured to “no limit”. It is recommended to use default value and if layer 3 MLD is in
operation, please make this configuration in accordance with the MLD configuration as
possible.
Example:
Switch(config)#ipv6 mld snooping vlan 2 limit group 300
17.4.3.7 ipv6 mld snooping vlan mrouter-port interface
Command: ipv6 mld snooping vlan <vlan-id> mrouter-port interface
(<ehternet>|<port-channel>)<ifname>
no
ipv6
mld
snooping
vlan
<vlan-id> mrouter-port interface
(<ehternet>|<port-channel>)<ifname>
Function:
Set the static mrouter port of the vlan; the “no” form of this command cancels
the configuration.
Parameter: vlan-id
: vlan id, the valid range is<1-4094>
ehternet：name of Ethernet port
ifname：Name of interface
port-channel: port aggregate
Command Mode: Global Mode
Default:
When a port is made static and dynamic mrouter port at the same time, it’s the
static mrouter properties is preferred. Deleting the static mrouter port can only be done
with the “no” form of this command.
Example:
Switch(config)#ipv6 mld snooping vlan 2 mrouter-port interface ethernet1/13
17.4.3.8 ipv6 mld snooping vlan mrpt
Command: ipv6 mld snooping vlan <vlan-id> mart <value>
no ipv6 mld snooping vlan <vlan-id> mart
Function:
Configure the keep-alive time of the mrouter port.
Parameter: vlan-id
: vlan id, the valid range is <1-4094>
value：mrouter port keep-alive time with a valid range of <1-65535> secs.
Command Mode:
Global Mode
Default:
255s
Usage Guide:
This configuration is applicable on dynamic mrouter port, but not on static
mrouter port. To use this command, MLD snooping must be enabled on the vlan.