Accton Technology ES4626 - Manual (Page 328)

328
Switch(dhcp-1-config)#lease 3 12 30
10.2.2.14 netbios-name-server
Command: netbios-name-server <address1>[<address2>[…<address8>]]
no netbios-name-server
Function: Configures WINS servers’ address; the “no netbios-name-server” command
deletes the WINS server.
Parameters: address1…address8 are IP addresses, in decimal format.
Default:
No WINS server is configured by default.
Command Mode: DHCP Address Pool Mode
Usage Guide: This command is used to specify WINS server for the client, up to 8 WINS
server addresses can be configured. The WINS server address assigned first has the
highest priority. Therefore, address 1 has the highest priority, and address 2 the second,
and so on.
10.2.2.15 netbios-node-type
Command: netbios-node-type ｛b-node|h-node|m-node|p-node|<type-number>｝
no netbios-node-type
Function: Sets the node type for the specified port; the “no netbios-node-type”
command cancels the setting.
Parameters: b-node stands for broadcasting node, h-node for hybrid node that
broadcasts after point-to-point communication; m-node for hybrid node to communicate
in point-to-point after broadcast; p-node for point-to-point node; <type-number> is the
node type in Hex from 0 to FF.
Default: No client node type is specified by default.
Command Mode: DHCP Address Pool Mode
Usage Guide: If client node type is to be specified, it is recommended to set the client
node type to h-node that broadcasts after point-to-point communication.
Example: Setting the node type for client of pool 1 to broadcasting node.
Switch(dhcp-1-config)#netbios-node-type b-node
10.2.2.16 network-address
Command: network-address <network-number> [<mask> | <prefix-length>]
no network-address
Function: Sets the scope for assignment for addresses in the pool; the “no
network-address ” command cancels the setting.
Parameters:
<network-number> is the network number; <mask> is the subnet mask in
the decimal format; <prefix-length> stands for mask in prefix form. For example, mask