Accton Technology ES4626 - Manual (Page 689)

689
Switch (Config)# ipv6 access-list myfilter permit any
17.1.3.8 ipv6 pim state-refresh origination-interval
Command: ipv6 pim state-refresh origination-interval <interval>
no ipv6 pim state-refresh origination-interval
Function: Configure transmission interval of state-refresh message on interface. The “no
ipv6 pim state-refresh origination-interval” command restores default value.
Parameter:
<interval> message transmission interval value is from 4s to 100s.
Default: 60s
Usage Guide: The first-hop router periodly transmits stat-refresh messages to maintain
PIM-DM list ltems of all the downstream routers. The command can modify origination
interval of state-refresh messages. Usually do not modify relevant timer interval. The
command can configure on IPv6 tunnel interface, but it is successful configuration to only
configure tunnel carefully.
Example:
Configure transmission interval of state-refresh message on interface vlan1 to
90s.
Switch (Config-if-Vlan1)#ipv6 pim state-refresh origination-interval 90
17.1.4 PIM-DM Typical Application
As shown in the following figure, add the Ethernet interfaces of Switch A and Switch
B to corresponding vlan, and start PIM-DM Protocol on each vlan interface.
Fig 17-1 PIM-DM Typical Environment
The configuration procedure for SwitchA and SwitchB is as below:
(1) Configure SwitchA:
Switch (Config) # ipv6 pim multicast-routing
Switch (Config) # interface vlan 1
Switch (Config-if-Vlan1) # ipv6 address 2000:10:1:1::1/64
SwitchA SwitchB
Vlan 2 Vlan 1 Vlan 2 vlan 1