Accton Technology ES4626 - Manual (Page 501)

501
backbone layer3 switches, Swtich2 and SwitchD are area edge layer3 switches, and
Switch3 is the in-area layer3 switch.
Fig 13-9 Network topology of OSPF autonomous system.
The configuration for layer3 SwitchA and SwitchD is shown below:
Layer3 SwitchA:
! Enable OSPFv3 protocol, configure router ID
SwitchA(config)#router IPv6 ospf
SwitchA (config-router)#router-id 192.168.2.1
Configure interface vlan1 IPv6 address and affiliated OSPFv3 area
SwitchA#config
SwitchA(config)# interface vlan 1
SwitchA(config-if-vlan1)# IPv6 address 2010:1:1::1/64
SwitchA(config-if-vlan1)# IPv6 router ospf area 0
SwitchA(config-if-vlan1)#exit
Configure interface vlan2 IP address and affiliated OSPFv3 area
SwitchA(config)# interface vlan 2
SwitchA(config-if-vlan2)# IPv6 address 2100:1:1::1/64
SwitchA(config-if-vlan2)# IPv6 router ospf area 0
SwitchA (config-if-vlan2)#exit
SwitchA(config)#exit
Layer 3 SwitchB:
Enable OSPFv3 protocol, configure router ID
SwitchB(config)#router IPv6 ospf
SwitchB (config-router)#router-id 192.168.2.2
Configure interface vlan1 address, vlan2 IPv6 address and affiliated OSPFv3 area
SwitchB#config
SwitchB(config)# interface vlan 1
SwitchB(config-if-vlan1)# IPv6 address 2010:1:1::2/64
SwitchB(config-if-vlan1)# IPv6 router ospf area 0
SwitchB(config-if-vlan1)#exit
Area 1
Area 0
Area 2
SWITCHD
E1/1:2100:1:1::1/64
vlan2
E1/2:2010:1:1::1/64
vlan1
E1/1: 2010:1:1::2/64
vlan1
E1/2: 2020:1:1::1/64
vlan3
E1/1: 2020:1:1::2/64
vlan3
E1/2:2030:1:1::1
vlan3
E1/1:2100:1:1::2/64
vlan2
E1/1: 2030:1:1::2/64
vlan3
SwitchE SwitchA
SwitchD SwitchC
SwitchB