Accton Technology ES4626 - Manual (Page 494)

494
Switch(config)#router ipv6 ospf
Switch(config-router)#default-metric 100
13.7.3.7 ipv6 ospf cost
Command: ipv6 ospf cost <cost> [instance-id <id>]
no ipv6 ospf cost [instance-id <id>]
Function: Specify the cost required in running OSPF protocol on the interface; the “no
ipv6 ospf cost [instance-id <id>] ” command restores the default value
Parameter: <id>
is the interface instance ID, ranging between 0~255, defaulted at 0
<cost > is the cost of OSPF protocol ranging between 1~65535
Default: Default OSPF cost on the interface is 10
Command Mode: Interface Mode
Usage Guide: The command can configure on IPv6 tunnel interface, but it is successful
configuration to only configure tunnel carefully.
Example:
Switch#config terminal
Switch(config)#interface vlan 1
Switch(Config-if-Vlan1)#ipv6 ospf cost 3
13.7.3.8 ipv6 ospf dead-interval
Command: ipv6 ospf dead-interval <time > [instance-id <id>]
no ipv6 ospf dead-interval [instance-id <id>]
Function:
Specify the dead interval for neighboring layer 3 switch; the “no ipv6 ospf
dead-interval [instance-id <id>] ” command restores the default value.
Parameter: <id> is the interface instance ID, ranging between 0~255, defaulted at 0
<time > is the length of the adjacent layer 3 switch, in seconds, ranging between 1～
65535
Default: The default dead interval is 40 seconds (normally 4 times of the hello-interval).
Command Mode: Interface Mode
Usage Guide:
If no HELLO data packet received after the dead-interval period then
this layer 3 switch is considered inaccessible and invalid. This command modifies the
dead interval value of neighboring layer 3 switch according to the actual link state. The
set dead-interval value is written into the Hello packet and transmitted. To ensure the
normal operation of the OSPF protocol, the dead-interval between adjacent layer 3
switches should be in accordance or at least 4 times of the hello-interval value. The
command can configure on IPv6 tunnel interface, but it is successful configuration to only
configure tunnel carefully.
Example: