Lenze EVS9332xK - Manual (Page 219)

Commissioning
Transfer of motion profiles
Transfer of profile data from GDC to the controller
6
6.11
6.11.3
l
6.11−3 EDSVS9332K EN 8.0−07/2013
6.11.3 Transfer of profile data from GDC to the controller
1
2
9300kur073
Fig. 6.11−3 Cam editor" dialog box
Procedure
1. Click on the "Transfer data" button (1) to transfer the profile data to the background data
field (RAM2) of the controller.
l The data of all profiles created are transferred. The transmission takes approx.
1 ... 2 minutes.
Important!
Transfer the parameter set with the gearbox and feed constants first and then the profile
data.
2. Click on the "Accept data" button (2) to accept the transferred profile data in the active
data field (RAM1) of the controller.
Note!
Via PLC/IPC you can accept the profile data with the CDATA−LOAD" command (C1322/7).
1
3
2
9300kur031
Fig. 6.11−4 "Basic cam data" dialog box
Procedure
1. Click on the "Profile upload" button (1) to transfer the profile data from the active data
field (RAM1) of the controller to GDC.
Important!
Do not process the profile data in the editor!
The conversion of profile data is inexact because in the controller the profile data is stored
in the 32−bit format, while the editor works with the 64−bit format.
2. Click on the "CAM download" button (3) to transfer the profile data to the active data
field (RAM1) of a controller.
3. If required, click on the "CAM store" button (2) to save the profile data in an LC7 file
(formatted in ASCII).
Transfer of data created with
the cam editor to the
controller
Data transfer between
controllers