Lenze EVS9332xK - Manual (Page 286)

Configuration
Code table
8
8.4
l
8.4−12 EDSVS9332K EN 8.0−07/2013
IMPORTANT Possible settings Code
Selection Lenze Designation No.
C0183 DIAGNOSTICS g
Drive diagnostics
l Indicates fault or status information
l If several fault or status information units
are active simultaneously, the information
unit with the smallest number is displayed
0 OK No fault
91 TRIP set C0135 TRIP via LECOM−A/B/LI or keypad
92 Trip−Set AIF TRIP via AIF
93 Trip set CAN TRIP via CAN
101 Initialisation Initialisation phase
102 TRIP/fault TRIP active
103 Emergency stop Emergency stop has been executed
104 Pulse inhibit message Message active
105 Power OFF Function is not supported
111 Operation inhibit−C135
Operation inhibited 112 Operation inhibit−AIF
113 Operation inhibit−CAN
121 Controller inhibit, terminal 28 Controller inhibited via X5/28
122 Controller inhibit, internal 1 DCTRL−CINH1
123 Controller inhibit, internal 2 DCTRL−CINH2
124 Controller inhibit−C135/STOP STOP key at the keypad
125 Controller inhibit−AIF Controller inhibited via AIF
126 Controller inhibit−CAN Controller inhibited via system bus
141 Switch−on inhibit Restart protection active
142 Pulse inhibit High−resistance power outputs
151 QSP−terminal, external quick stop Quick stop via MCTRL−QSP
152 QSP−C135 quick stop Quick stop via STOP key of the keypad
153 QSP−AIF quick stop Quick stop via AIF
154 QSP−CAN quick stop Quick stop via system bus
250 Warning C168 Warning active
C0190 NSET ARIT 0 0
1
2
3
4
5 OUT = C46
C46 + C49
C46 − C49
C46 * C49
C46 / C49
C46/(100 − C49) NSET
Arithmetic block in the function block NSET
Connects main setpoint C0046 and additional
setpoint C0040
C0195 BRK1 T ACT 99.9 0.0 {0.1 s} 99.9 BRK1 brake engagement time
Engagement time of the mechanical holding
brake
l After the time under C0195 has elapsed,
the status "mechanical brake closed" is
reached
C0196 BRK T RELEASE 0.0 0.0 {0.1 s} 60.0 BRK1 brake disengagement time
Disengagement time of the mechanical
holding brake (see technical data of the
brake).
l After the time under C0196 has elapsed,
the status "mechanical brake open" is
reached
C0200 S/W ID g Software ID
Software identification
C0201 S/W DATE g Software release
Date of software release