Lenze EVS9332xK - Manual (Page 283)

Configuration
Code table
8
8.4
l
8.4−9 EDSVS9332K EN 8.0−07/2013
IMPORTANT Possible settings Code
Selection Lenze Designation No.
C0126 MONIT CE0 3 0
2
3 TRIP
Warning
Off Configuration of CE0
Configuration of communication error
monitoring with automation interface CE0
C0127 OC8 LIMIT 0 0 {1 %} 120 Threshold for I 2 × t advance warning (motor)
l 0 = I 2 × t advance warning switched off
l I 2 × t > C0127 ð Fault message OC8
(response set in C606)
C0128 TAU MOTOR 5.0 0.1 {0.1 min} 50.0 Thermal time constant of the motor
The time constant is required for calculating
the I
2 × t disconnection.
C0130 ACT TI g NSET act. Ti times
Active T
i
times of NSET
C0134 RFG CHARAC 0 0
1 Linear
S−shaped NSET RFG characteristic
Characteristic of ramp function generator for
main setpoint
C0135 CONTROL
WORD
0 0 {1} 65535 Control word
Controller control word for LECOM−A/B/LI or
keypad.
C0136 g
1 CTRLWORD
C135
Control word C135
2 CTRLWORD
CAN
Control word CAN
3 CTRLWORD AIF Control word AIF
C0141 FCODE
(SETVAL)
0.0 −199.9 {0.1 %} 199.9 Main setpoint
C0142 START
OPTIONS
1 Start options
0 Start lock l Automatic start inhibited after
– mains connection
– cancelling of a message (t > 0.5 s)
– TRIP reset
l Start after HIGH−LOW−HIGH level change
at X5/28
1 Auto start Automatic start when X5/28 = HIGH
C0150 STATUS WORD g 0 {1} 65535 Status word when networked with
automation interfaces
l Binary interpretation indicates the bit
states
C0151 FDO (DW) g Display (hex.) of the free digital output
signals configured with C0116
l Binary interpretation indicates the bit
states
C0155 STATUS WORD
2
g Bit00 Fail Bit08 CW/CC
W Status word 2
Extended decimal status word
l Binary interpretation indicates the bit
states
Bit01 Mmax Bit09 —
Bit02 Imax Bit10 —
Bit03 IMP Bit11 —
Bit04 RDY Bit12 —
Bit05 CINH Bit13 —
Bit06 Trip Bit14 —
Bit07 Init Bit15 —