Activating password protection, Parameter setting – Lenze EVS9332xK User Manual
Page 251
Parameter setting
Parameter setting with the XT EMZ9371BC keypad
Activating password protection
7.2
7.2.7
l
7.2−9
EDSVS9332K EN 8.0−07/2013
7.2.7
Activating password protection
)
Note!
ƒ
If the password protection is activated (C0094 = 1 ... 9999), you
only have free access to the user menu.
ƒ
To access the other menus, you must enter the password. By
this, the password protection is annulled until you enter a new
password.
ƒ
Please observe that the password−protected parameters can
be overwritten as well when transferring the parameter sets
to other standard devices. The password is not transferred.
ƒ
Do not forget your password! If you have forgotten your
password, it can only be reset via a PC or a bus system!
Step
Key
sequence
Action
1.
Select the "USER menu"
z y Z Y
Change to the user menu using the arrow
keys
2.
Change to the code level
Z
Display of code C0051 "MCTRL−NACT"
3.
Select C0094
z
Display of code C0094 "Password"
4.
Change to the parameter level
V
Display "0" = no password protection
5.
Set password
A
z
Select password (1 ... 9999)
B
T V
Confirm password
6.
Change to the code level
A
V
Display of the operating level
B
V
Display of C0094 and "Password"
7.
Change to the "USER menu"
Y Y y
The password protection is active now.
You can only quit the user menu if you re−enter the password and confirm it with
T V
.
Step
Key
sequence
Action
1.
Change to the code level in the
user menu
Z
2.
Select C0094
z
Display of code C0094 "Password"
3.
Change to the parameter level
V
Display "9999" = password protection is
active
4.
Enter password
A
y
Set valid password
B
T V
Confirm
The password protection is deactivated by
entering the password once again.
5.
Change to the code level
A
V
Display of the operating level
B
V
Display of C0094 and "Password"
The password protection is deactivated now. All menus can be freely accessed again.
Activate password protection
Remove password protection