Lenze EVS9332xK - Manual (Page 333)

Configuration
Code table
8
8.4
l
8.4−59 EDSVS9332K EN 8.0−07/2013
IMPORTANT Possible settings Code
Selection Lenze Designation No.
C1316
g {1 inc} CDATA
Final Y value
1 Curve 0
... ...
8 Curve 7
C1317 0 CDATA
0 Load with ctrl. inhibit Reloading profiles with controller inhibit
1 Load without ctrl. inhibit Reloading profiles without controller inhibit
C1318 0 0
1
2 Adapt stop value
Maintain stop value
Maintain sections TEACH mode
C1319 0 CDATA
Stretching/compression mode
0 DFIN * XFACT / 100% l Use of XFACT as multiplier:
– XFACT = +100 %
l No stretching/compression:
– XFACT = −100 %
l No stretching/compression but reversal of
direction for X position. The profile will be
processed from the end:
– XFACT > 100 %
l Leads to compression:
– XFACT < 100 %
1 DFIN * 100% / XFACT l Use of XFACT as divisor (reciprocal value):
– Values < 1 % at input XFACT are
internally limited to +1 %
l If stretching/compression is not wanted:
– Connect XFACT with FIXED100%
(default setting)
C1320
s
® Selection list 1 CDATA, CURVEC1
1 1000 FIXED0% CURVEC1−AIN
2 1006 FIXED100% CDATA
CDATA−XFACT
Stretching/compression factor:
l +100 % = no stretching/compression
l >100 % = compression
l <100 % = stretching
3 1000 FIXED0% CDATA
CDATA−SEL
Profile selection:
0 = profile 0 (1st profile)
C1321 g
1 (C1320/1)
2 (C1320/2)
3 (C1320/3)