Lenze EVS9332xK - Manual (Page 342)

Configuration
Code table
8
8.4
l
8.4−68 EDSVS9332K EN 8.0−07/2013
IMPORTANT Possible settings Code
Selection Lenze Designation No.
C1400
s
® Selection list 2 RFGPH1
1 RFGPH1−RESET 1000 FIXED0 l HIGH sets RFGPH1−OUT = 0 (jump)
l LOW sets RFGPH1−OUT to the value at
RFGPH1−IN according to the selected
function
l Input has priority over RFGPH1−RFG−0
2 RFGPH1−RFG−0 1000 FIXED0 l HIGH sets RFGPH1−OUT = 0 according to
the selected function
l LOW sets RFGPH1−OUT to the value at
RFGPH1−IN according to the selected
function
3 RFGPH1−T/DIST 1000 FIXED0 Function changeover:
l HIGH = path−based path change
l LOW = time−based path change
C1401 g RFGPH1
Display of digital input signals
1 (C1400/1)
2 (C1400/2)
3 (C1400/3)
C1402
s
® Selection list 3 RFGPH1
Configuration of input signals
1 RFGPH1−IN 1000 FIXED0INC Position setpoint (65536 inc. = 1 rev.)
2 RFGPH1−DIST 1000 FIXED0INC Path difference by which the phase is to be
changed at the input RFGPH1−IN
(65536 inc. = 1 rev.)
C1403 g RFGPH1
Display of input signals
1 (C1402/2)
2 (C1402/2)
C1404
s
RFGPH1−DFIN 1000 FIXEDPHI−0 ® Selection list 4 RFGPH1
Configuration of digital frequency input
signals
C1405 (C1404) g RFGPH1
Display of input signal
C1408 300.0
000
−16000.0000 {0.0001
rpm}
16000.0000 RFGPH1
Speed
C1409
s
0 0
1
2 With absolute value generation
Without absolute value generation
Without absolute value with end RFGPH1
Mode
C1410
s
0 0
1
2
3 Directly engaged
To open position
To target position
Engage at set position CLUTCH1
Clutch mode
C1411 200.0
000
1 {0.0000
rpm}
16000.0000 CLUTCH1
Maximum speed
C1412 0.010 {0.010 s} 130.000 CLUTCH1, CLUTCH2
1 1.000 CLUTCH1: Disengagement time/ramp
2 1.000 CLUTCH1: Profile generator ramp
3 1.000 CLUTCH1: Overload time delay
4 1.000 CLUTCH2: Disengagement time
5 1.000 CLUTCH2: Profile generator ramp
C1413 5 {1 inc.} 32767 CLUTCH1, CLUTCH2
1 163 CLUTCH1: Catch hysteresis
2 163 CLUTCH2: Catch hysteresis