Rockwell Automation 8520-MUM 9/Series CNC Mill Operation and Programming Manual Documentation Set - Manual (Page 128)

Editing Programs Online
Chapter 5
5-14
Follow these steps to assign or renumber sequence numbers:
1. From the edit menu, press the continue softkey {
•
} to change the
softkey functions.
2. Press the {RENUM PRGRAM} softkey
DIGITZ
E
MODIFY
INSERT
BLOCK
DELETE
BLOCK
TRUNC
DELETE
CH/WRD
EXIT
EDITOR
STRING
SEARCH
RENUM
PRGRAM
MERGE
PRGRAM
QUICK
VIEW
CHAR/
WORD
(softkey level 3)
3. Key in an initial sequence number (the number for the first sequence
number), a comma, and an incremental value for the control to add to
each new sequence number. The format to this command is:
RENUM: initial-sequence-number, incremental-value
For example
RENUM:5,10
Would make the first sequence number 5, the next 15, 25, 35....
Important: Both the initial sequence number and the incremental value
must be entered as integer values. If a decimal point is used the control
will issue the error message “ILLEGAL VALUE”.
If no initial sequence number or no incremental-value is given or
both are not entered the control will use default values of one.