Rockwell Automation 8520-MUM 9/Series CNC Mill Operation and Programming Manual Documentation Set - Manual (Page 178)

Editing Part Programs Offline
Chapter 6
6-14
The workstation displays the part program files that are stored on the
control or storage device:
F1 - File F2 - Project F3 - Application F4 - Utility F5 - Configuration
Proj: Demo Appl: Part Program Util: Get Part Program
FILE1 FILE2 FILE3
Upload From...
Use ARROW keys or Type in name. Press ENTER when done, or ESC to cancel.
8. Use the arrow keys to highlight the name of the part program to be
uploaded to the workstation or type in the part program name, then
press
[ENTER] .
When you upload a program from the control, the control does not display
a message to indicate that an upload is taking place. If you upload a large
program it may take several minutes for the upload to complete. If you try
to edit the program while it is uploading you see an error message that says
the program is already open. You have to wait until the upload is complete
to edit the program.
Important: It is possible to upload more than one part program using
wildcards (”*” or ”?”) in place of all or part of a file name. Refer to the
workstation’s DOS manual for additional information on using wildcards.