Rockwell Automation 8520-MUM 9/Series CNC Mill Operation and Programming Manual Documentation Set - Manual (Page 151)

Editing Programs Online
Chapter 5
5-37
To delete part programs stored in memory:
1. Press the {PRGRAM MANAGE} softkey.
(softkey level 1)
PRGRAM
MANAGE
OFFSET MACRO
PARAM
QUICK
CHECK
SYSTEM
SUPORT
FRONT
PANEL
ERROR
MESAGE
PASS-
WORD
SWITCH
LANG
2. Press the {DELETE} softkey.
REFORM
MEMORY
ACTIVE
PRGRAM
EDIT
PRGRAM
RESTRT
PRGRAM
DISPLY
PRGRAM
COPY
PRGRAM
VERIFY
PRGRAM
PRGRAM
COMENT
DELETE
PRGRAM
RENAME
PRGRAM
INPUT
DEVICE
(softkey level 2)
CAUTION: Once a program has been deleted from memory it
can not be recovered. Abort the delete program operation by
pressing the {DELETE NO} softkey.
Here there are two choices:
Key-in the the program name and press the {DELETE YES} softkey.
Move the block cursor down until the desired program is in reverse
video and press the {DELETE YES} softkey.
DELETE
YES
DELETE
NO
(softkey level 3)
It is possible to delete all programs at once by formatting the RAM disk
as described in chapter 2.
5.5
Deleting Program {DELETE
PRGRAM}