Rockwell Automation 8520-MUM 9/Series CNC Mill Operation and Programming Manual Documentation Set - Manual (Page 886)

Error and System Messages
Appendix B
B-14
Message Description
EXTRA KEYBOARD OR HPG ON I/O RING The control detected a keyboard or HPG on the 9/Series fiber optic ring that was not configured
as a ring device. The I/O ring will still function and the control will NOT be held in E-Stop. You
may also use the keyboard or HPG by selecting it as the active device via the corresponding
PAL flags. You should configure the keyboard or HPG with the I/O assigner utility (See your
9/Series PAL reference manual for details).
F
FCM DUALPORT RAM FAILURE The FCM detected an error in dualport RAM.
FCM FLASH RAM FAILURE The FCM detected an error in flash RAM.
FCM LOCAL RAM FAILURE The FCM detected an error in local RAM at power-up or during the runtime diagnostics.
FCM PLUG CONFIGURE FAILED The FCM card failed to configure correctly.
FCM PLUG FAULT The plug on the FCM detected an error.
FCM PLUG NEGOTIATE FAILED The FCM firmware could not communicate with the plug.
FCM POWER UP SEQUENCE FAILURE Power-up failed. Try again. If error appears again, contact your Allen-Bradley sales
representative.
FCM REVISION CHECK FAILURE Revision on module is out-of-date. Contact Allen-Bradley sales representative to get latest
revision of the module’s firmware.
FCM ROM FAILURE The FCM detected an error in ROM during runtime diagnostics.
FCM SHADOW RAM FAILURE The FCM detected an error in shadow RAM.
FCM SPURIOUS INTERRUPT A spurious interrupt occurred on the FCM card.
FCM VRTX ERROR A call from VRTX from the FCM card firmware returned an error.
FCM WATCHDOG The watchdog on the FCM card timed out.
FDBK NOT AVAILABLE ON 4TH AXIS OF BOARD An attempt was made to receive feedback from the axis that is configured as the fourth axis on a
servo board. You can only receive feedback from the first three axes on a servo board.
FEEDBACK DISCONNECTED The control has detected a loss of feedback from the encoder. The most likely cause of this
error would be a broken or disconnected wire. Axis homing will be required after the error
condition is corrected.
FEEDBACK OPTION NOT INSTALLED A PTO check determines the legal number of axes.
FEED AXIS DATA NOT PROGRAMMED Feed axis data required during a grinder fixed cycle was not programmed.
FEED AXIS MOTION NOT ALLOWED During Virtual C programming, no axis motion is allowed on the axis specified as the feed axis in
AMP.
FEED TO HARDSTOP PROGRAMMING ERROR No axis, or more than one axis, was programmed in a G24 block. Or the programmed axis
integrand was not programmed in the block.
FILE CANNOT BE CONVERTED TO EIA FORMAT The file requested to be output to a device has characters that cannot be converted to EIA.
FILE DOWNLOAD COMPLETE Status message that means the download has completed.
FILE DOWNLOAD ERROR Check file download and file download configuration screens to make sure all fields are entered
correctly.
FILE DOWNLOAD IN PROGRESS This status message means a file is being downloaded.
FIXED CYCLE ALREADY ACTIVE You cannot program a fixed cycle with a fixed cycle already active.
FIXED CYCLE PROGRAMMING ERROR A fixed cycle has been programmed incorrectly. Verify that the correct parameters have been
used and that parameters restricted to integer or positive values are programmed as such.
FLASH IN USE -- TRY AGAIN LATER Only one task is allowed to write flash at a time. If a second task requests a flash write, you will
see this message.
FLASH SIMMS ARE NOT INSTALLED Install the flash SIMMs into the 9/Series mother board. Flash SIMMs must be installed. If a
repaired system is being installed, you should have saved your flash SIMMs for re-installation
before making the return.