Rockwell Automation 8520-MUM 9/Series CNC Mill Operation and Programming Manual Documentation Set - Manual (Page 172)

Editing Part Programs Offline
Chapter 6
6-8
7. Use the arrow keys to highlight the download destination or press the
letter that corresponds to the download destination. When selected
press
[ENTER] .
The workstation displays the part program files that are stored in the active
project directory of the workstation:
F1 - File F2 - Project F3 - Application F4 - Utility F5 - Configuration
Proj: Demo Appl: Download Util: File Management
FILE1 FILE2 FILE3
Downloading
Use ARROW keys or Type in name. Press ENTER when done, or ESC to cancel.
8. Use the arrow keys to highlight the name or type in the part program
name to download, then press
[ENTER]
.
When you download a program to the control, the control does not
display a message to indicate that a download is taking place. If you
download a large program it may take several minutes for the control
to complete the download. You may want to go to the directory
screen and monitor the download. As the program downloads, the
control updates the size of the program.
Important: It is possible to upload more than one part program using
wildcards (”*” or ”?”) in place of all or part of a file name. Refer to
the workstation’s DOS manual for additional information on using
wildcards.