Rockwell Automation 8520-MUM 9/Series CNC Mill Operation and Programming Manual Documentation Set - Manual (Page 227)

Displays and Graphics
Chapter 8
8-11
{TARGET} (Small Display)
The coordinate values of the end point of the currently executing axis
move is displayed at a position in the current work coordinate system for
all system axes in the active process (only available when more than 9 axes
are AMPed in the system, or more than 8 axes in the process for dual
process systems).
Figure 8.9
Results After Pressing {TARGET} (Small Display) Softkey
PRGRAM A B S TARGET D T G AXIS
SELECT
TARGET [ MM ]
X -9999.647
Y -3333.647
Z -1111.647
U -2222.647
V -2222.647
W -2222.647
A -2222.647
B -2222.647
C -2222.647
$X -2222.647
$Y -2222.647
$Z -2222.647
F 0.000 MMPM S 00