Rockwell Automation 8520-MUM 9/Series CNC Mill Operation and Programming Manual Documentation Set - Manual (Page 422)

Using QuickPath Plus
Chapter 15
15-4
Figure 15.1
Results of Angle Designation Example 15.1
165
•
Y
X
5 10 15 20 25
20
15
10
5
Important: An arc may also use an angle (,A) program block. This is
discussed in chapter 16.
No end coordinate known (L)
This feature of QPP allows the programmer to define a tool path using only
the start point angle and length of a tool path. This must be a linear block.