Rockwell Automation 8520-MUM 9/Series CNC Mill Operation and Programming Manual Documentation Set User Manual
Page 812
Using Transfer Line Cycles
Chapter 31
31-10
3.
Once the correct cycle is selected, press the {SELECT} softkey. A
screen with prompts for that cycle and a graphical representation of
that cycle is displayed.
STORE
TRANSFER VELOCITY
F1_____
FULL ADVANCE POSITION
X1_____
FULL RETURN POSITION
X2_____
HARD STOP SENSE ZONE
I______
SINGLE AXIS TRANSFER CYCLE
F1
F1
X1
X2
I
4.
Use the up and down cursor keys to select the parameters to be
changed or entered. The selected item is shown in reverse video.
Axis words followed by a 1 or 2 are prompting for the first and
second coordinate positions respectively.
Prompts that are shown in reverse video indicate that this parameter
is optional and doesn’t need to be entered in this block.
5.
Type in the desired data for that parameter on the input line of the
CRT and press the [TRANSMIT] key.
Refer to the template descriptions at the end of this chapter for
definitions of the prompts. These template descriptions assume that
the default axis names of X and Y have not changed in AMP.