Rockwell Automation 8520-MUM 9/Series CNC Mill Operation and Programming Manual Documentation Set User Manual
Page 254
Displays and Graphics
Chapter 8
8-38
4.
Press the {ENTER MESAGE} softkey. This highlights the softkey,
and the control displays the input prompt “PTO MESSAGE:” at the
top of the screen. Also, the current text, if any, of the selected
message line is shown on the input line next to the prompt. (The text
may be edited like any other input string.)
(softkey level 3)
ENTER
MESAGE
STORE
BACKUP
5.
Once the line has been edited, press the <TRANSMIT> key. This
transfers the edited line to the PTO screen. After pressing the
<TRANSMIT> key, you can either:
edit another line
6.
To save changes to the system integrator message lines, press the
{STORE BACKUP} softkey. When pressed, the softkey will be
shown in reverse video until the control has finished storing the lines.
Important: If the messages are not stored to EEPROM, the text will be
lost the next time the system is powered down.
(softkey level 3)
ENTER
MESAGE
STORE
BACKUP