Rockwell Automation 8520-MUM 9/Series CNC Mill Operation and Programming Manual Documentation Set - Manual (Page 652)

Milling Fixed Cycles
Chapter 26
26-20
The format for the G82 cycle is as follows:
G82X__Y__Z__R__P__F__L__;
Where : Is :
X,Y specifies location of the hole.
Z defines the hole bottom.
R defines the R point level.
P defines the dwell period at hole bottom.
F defines the cutting feedrate.
L defines the number of times the milling fixed cycle is repeated.
(See section 26.3 for a detailed explanation of these parameters.)
Important: The programmer or operator must start spindle rotation.
Figure 26.9
G82: Drilling Cycle, Dwell/Rapid Out
initial point
level
Cutting feed
Rapid feed
R
Z
Dwell at hole bottom
Hole bottom
R point level
1
2
3
4
5
(G82): Drill Cycle,
Dwell/Rapid Out