Rockwell Automation 8520-MUM 9/Series CNC Mill Operation and Programming Manual Documentation Set User Manual
Page 193
Running a Program
Chapter 7
7-11
3.
Press the {SEARCH} softkey.
(softkey level 3)
DE-ACT
PRGRAM
SEARCH MID ST
PRGRAM
T PATH
GRAPH
SEQ
STOP
TIME
PARTS
4.
You can search 6 ways:
To search:
Press this softkey:
for a sequence number
{N SEARCH}
for an O word
{O SEARCH}
for the end of each block
{EOB SEARCH}
the program one line at a time
{SLEW}
for a specific character string
{STRING SEARCH}
for the beginning of your next program
{NEXT PRGRAM}
The {NEXT PRGRAM} softkey is available only if your input device is
configured as a tape reader. Refer to section 7.2 on input device selection.
(softkey level 4)
N
SEARCH
O
SEARCH
EOB
SEARCH
SLEW
STRING
SEARCH
NEXT
PRGRAM
5.
When using the SLEW or the EOB search options, press the
{FORWRD} or {REVRSE} softkeys to move to the next or previous
blocks in the program. Press the {TOP OF PRGRAM} softkey to
return to the top of the program (the beginning of the first block).
Press the {EXIT} softkey when the desired block is found. The
selected block will be the next block for automatic execution.
Important: When performing an EOB search, the search is executed from
the beginning of the part program, NOT from the point of display.