Rockwell Automation 8520-MUM 9/Series CNC Mill Operation and Programming Manual Documentation Set - Manual (Page 161)

Editing Programs Online
Chapter 5
5-47
The control displays the set-up encryption screen:
UPDATE
& EXIT
STORE
BACKUP
REVRSE
FILL
ENTER A CHARACTER:
= . = 9 = D = O = Z =
” = / = : = E = P = [ =
# = 0 = ; = F = Q = ] =
% = 1 = < = G = R =
& = 2 = = = H = S =
( = 3 = > = I = T =
) = 4 = ? = J = U =
* = 5 = @ = K = V =
+ = 6 = A = L = W =
’ = 7 = B = M = X =
- = 8 = C = N = Y =
You must fill in the encryption/decryption table. During the
encryption/decryption process, the control uses this table to guide the
character substitution that provides an encrypted or decrypted part
program. You can fill in this table by using the operator panel keys
or the {REVRSE FILL} softkey.
To fill in the encryption/decryption table by using the operator panel
keys:
use the arrow keys to move the cursor to the place where you want
to assign an encryption/decryption character
then enter a character and press the [TRANSMIT] key
You must enter a unique character for each character on the set-up
encryption screen.