Rockwell Automation 8520-MUM 9/Series CNC Mill Operation and Programming Manual Documentation Set - Manual (Page 272)

Communications
Chapter 9
9-16
Output All Programs
Press {OUTPUT ALL} to copy all programs in memory to tape at
one time.
{OUTPUT ALL} works like {MULTI PRGRAM} except
that you cannot select the programs you want to output.
{OUTPUT ALL} selects all programs automatically and
outputs them to the peripheral device.
All programs are copied to the peripheral device and stored
using the same program name as the original, in the order that
they appear on the Program Directory Screen.
(softkey level 3)
SINGLE
PRGRAM
MULTI
PRGRAM
OUTPUT
ALL
Figure 9.5
Copy Parameters Screen
COPY PARAMETERS
FROM: (Program Name)
TO: (Selected Port Name)
DEVICE: FACIT N4000
BAUD RATE: 2400
PROTOCOL: LEVEL_2*
OUTPUT CODE: ASCII
AUTO FILENAME: NO
STOP PRG END: YES
PROGRAM END: M02, M30
M99
CANCEL
Important: Press {CANCEL} to abort the copy operation at any time.