Rockwell Automation 8520-MUM 9/Series CNC Mill Operation and Programming Manual Documentation Set User Manual
Page 361
Coordinate Control
Chapter 13
13-9
Figure 13.6
Typical External Part Rotation Parameter Screen
EXTERN
ON/OFF
ENTER VALUE:
E-STOP
MODE = [ MM ]
EXTERNAL
PART
ROTATION
[ OFF ]
PLANE
X
Z
CENTER
-2.440
-2.600
VECTOR
0.000
0.000
ANGLE
15.000
PROGRAMMABLE
PART
ROTATION
ANGLE
0.000
3.
Move the cursor to the desired parameter to be changed by pressing
the up, down, left, right cursor keys. The selected parameter will be
shown in reverse video.
4.
Enter the new value for the desired parameter using the keys on the
keyboard. The entered value will be shown on the input line (lines 2
and 3) of the CRT. The value may be modified on the input line as
described in section 2.10.
5.
When the desired value is displayed on the input line of the CRT,
press the key. The value on the input line will replace the old
parameter value.
6.
Repeat until all parameters display the desired values.
7.
Activate the external part rotation feature by pressing the
{EXTERN ON/OFF} softkey. The external offset feature will toggle
between on and off each time this softkey is pressed.