Using hemisphere milling cycles – Rockwell Automation 8520-MUM 9/Series CNC Mill Operation and Programming Manual Documentation Set User Manual
Page 607

Chapter
24
24-1
Using Hemisphere Milling Cycles
This chapter describes how to use G88.5 and G88.6 to program hemisphere
milling cycles. Use this table to find information:
Information on:
On page:
Hemisphere Milling Roughing Cycle (G88.5)
24-1
Concave Hemisphere Roughing Using G88.5
24-2
Convex Hemisphere Roughing Using G88.5
24-5
Hemisphere Milling Finishing Cycle
24-7
Concave Hemisphere Finishing Using G88.6
24-8
Convex Hemisphere Finishing Using G88.6
24-10
Use the G88.5 hemisphere milling roughing cycle to rough out concave or
convex hemispherical pockets.
Important: The active plane is selected using G17, G18, or G19. In this
chapter it is assumed that G17, the XY plane, is selected as the active
plane.
Important: Tool length and diameter offsets must be entered and active
prior to the G88 block.
These features are prohibited during execution of pocket milling cycles:
MDI mode
Tool offset changes through the offset softkey
The following subsections cover using the G88.5 roughing cycle for
concave or convex hemispheres.
24.0
Chapter Overview
24.1
Hemisphere Milling
Roughing Cycle (G88.5)