Rockwell Automation 8520-MUM 9/Series CNC Mill Operation and Programming Manual Documentation Set - Manual (Page 231)

Displays and Graphics
Chapter 8
8-15
(9) {AXIS SELECT}
Important: {AXIS SELECT} is available only during a large character
display or when more than 9 axes are displayed on a normal size display.
When you press {AXIS SELECT}, the control displays the axis names in
the softkey area. Press a specific axis letter softkey to toggle the position
display of that axis on and off.
If a normal size display is being viewed and the system has more than 9
axes, the axis select features can also select the axes for these normal size
displays. This feature has no affect on small displays. Small displays
always show all axes (only available on systems with more than 9 axes or
on dual process systems with more than 8 axes in a process).
Figure 8.13
Results After Pressing {AXIS SELECT} Softkey
AXIS
X
AXIS
Z
AXIS
U
AXIS
W
AXIS
V
DISTANCE TO GO[ MM ] (ACTIVE PROGRAM NAME)
X 0.021
Z 0.000
U 0.000
F 0.000 MMPM S 00
E-STOP